Florida Pneumatic FP-660A Use and Care Manual download pdf (Page 5)

FLORIDA-PNEUMATIC.COM

Please contact 1-800-356-3392 for further assistance.

Operation

Operating the air hammer

Ƒ This Air Hammer is designed to operate on 90 PSIG.

Lower pressure (below 90 PSIG) will reduce performance

of the tool. Higher air pressure (over 90 PSIG) raises the

performance of the tool beyond its rated capacity and

could cause serious damage to the tool and the user.

Installing the chisel

WARNING: Disconnect the tool from the air supply before

servicing or changing accessories.

Ƒ To insert the chisel, press the loop on the retainer spring

to the side and push the chisel into the cylinder of the air

hammer. Release the loop.

Ƒ Ensure the chisel is properly held by the retainer spring

before use.

Removing the chisel

Ƒ Rotate the spring counterclockwise to remove the retainer

spring.

Ƒ Pull the chisel out of the air hammer.

WARNING: Do not operate the tool without the chisel in

cylinder or allow the chisel to be driven out of the cylinder. Internal

damage will result if the piston strikes the cylinder wall.

Operating the air hammer

Ƒ Place the cutting edge of the chisel against the work piece

and then press the trigger.

1 2 3 4 5 6 7 8

No comments

Florida Pneumatic FP-660A Use and Care Manual Page 5